|
Post by Admin on Feb 28, 2014 19:03:01 GMT
Once the hood cover is nice a tight take a staple gun and start adding staples the one bottom corner and work along the bottom of the frame pushing in as hard as you can. Working across to the opposite corner. Working up the sides and around the top corners. Then across the top till you can not fit anymore staples into the frame. The using a shape knife cut close to the edge and cut towards the frame and use that to follow. Slide the knife along the frame. Follow the frame till the whole material is cut out. Now you should have a hole the same shape as the glass thats going in. Now the seal should fit into the frame ready for the glass to go in.
|
|